NI PXIe-8840 Installation Guide
|
© National Instruments
|
3
14. Power on the chassis.
15. Verify that the controller boots. If it does not boot, refer to the
What If the NI PXIe-8840
Does Not Boot?
section later in this guide.
Figure 2 shows an NI PXIe-8840 controller installed in the system controller slot of an
NI PXIe-1082 chassis.
Figure 2.
NI PXIe-8840 Controller Installed in a PXI Express Chassis
How to Remove the Controller from the PXI Express
Chassis
The NI PXIe-8840 controller is designed for easy handling. To remove the unit from the
PXI Express chassis:
1.
Power off the chassis.
2.
Remove any cables that may be attached to the controller front panel.
3.
Unscrew the four bracket-retaining screws in the front panel.
4.
Press the injector/ejector handle down.
5.
Slide the unit out of the chassis.
What If the NI PXIe-8840 Does Not Boot?
Several problems can cause a controller not to boot. Here are some things to look for and
possible solutions.
Things to Notice
•
Which LEDs come on? The
Power OK
LED should stay lit. The
Drive
LED should blink
during boot as the disk is accessed.
1
NI PXIe-1082 Chassis
2
NI PXIe-8840 Controller
3
Injector/Ejector Rail
1
3
2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com