©
National Instruments Corporation
11
NI 5761R User Guide and Specifications
11. Wire the
error out
indicator of the Open FPGA VI Reference function
to the
error in
control of
the Read/Write Control
function.
12. Configure the Read/Write Control function by clicking the terminal section labeled
Unselected
,
and selecting
IO Module/AI 0 Data N
.
13. Add the
IO Module/AI 0 Data N-1
I/O item to the Read/Write Control function by clicking the
lower edge of the control node with the Positioning tool and dragging the edge down.
14. Wire an indicator to the output terminal of the
IO Module\AI 0 Data N node.
15. Wire an Indicator from the output terminal of the IO Module\AI 0 Data N-1 node.
16. Add the Close FPGA VI Reference function, located on the
FPGA Interface
palette, to the right
of the While Loop on the block diagram.
17. Wire the
FPGA VI Reference Out
indicator of the Read/Write Control
function to the
FPGA VI
Reference In
control of the Close FPGA VI Reference
function.
18. Wire the
error out
indicator of the Read/Write Control function
to the
error in
control of the
Close FPGA VI Reference function.
Your block diagram should now resemble the block diagram in Figure 6.
Figure 6.
5761SampleAcq(Host).vi Block Diagram
19. Save the VI as
5761SampleAcq(Host).vi
.
Running the Host VI
1.
Connect one end of an SMA cable to CH 0 on the front panel of the NI 5761 and the other end of
the cable to your DUT.
2.
Open the front panel of
5761SampleAcq(Host).vi
.
3.
Click the
Run
button to run the VI.
4.
The VI acquires data from the DUT on AI 0 Data N and AI 0 Data N-1.
5.
Click the
STOP
button on the front panel and close the VI.
Summary of Contents for NI-5761
Page 1: ...NI 5761...
