Chapter 2
Installation and Configuration
2-2
©
National Instruments Corporation
Use the following general instructions to install your NI 4350
(PCMCIA):
1. Write down your NI 4350 (PCMCIA) serial number on the
Hardware and Software Configuration Form
2. Turn off your computer. If your computer and operating system
support hot insertion, you can insert or remove the NI 4350
(PCMCIA) at any time, whether the computer is powered on or off.
3. Remove the PCMCIA slot cover on your computer.
4. Insert the 68-pin I/O connector of the NI 4350 (PCMCIA) into the
PCMCIA slot until the connector is firmly seated. Notice that the
NI 4350 (PCMCIA) connectors are keyed so that you can insert it
in only one way.
5. Run the NI-DAQ Configuration Utility to make sure that the
NI 4350 (PCMCIA) is configured.
6. Configure your accessory using the NI-DAQ Configuration Utility.
Your NI 4350 (PCMCIA) is now installed.
♦
NI 4350 (ISA)
You can install the NI 4350 (ISA) in any available ISA, AT, or XT slot
in your computer. However, for best noise performance, leave as much
room as possible between the NI 4350 (ISA) and other hardware.
Before installing your NI 4350 (ISA), consult your computer user
manual or technical reference manual for specific instructions and
warnings. Use the following general instructions to install your
NI 4350 (ISA):
1. Write down your NI 4350 (ISA) serial number on the
Hardware and Software Configuration Form
2. Turn off and unplug your computer.
3. Remove the top cover or access port to the I/O channel.
4. Remove the expansion slot cover on the back panel of the
computer.
Caution: The NI 4350 (ISA) is ESD/contamination sensitive. Handle the board
using the metal bracket or edges.
5. Insert the NI 4350 (ISA) in a 16-bit or 8-bit ISA slot. Although it
may fit tightly, do not force the instrument into place.
!
