Appendix B Error Codes
Measure Data Acquisition User Manual
B-18
© National Instruments Corporation
-10880
updateRateChangeErr
A change to the update rate is not
possible at this time because 1) when
waveform generation is in progress,
you cannot change the interval
timebase or 2) when you make several
changes in a row, you must give each
change enough time to take effect
before requesting further changes.
-10881
partialTransferCompleteError
You cannot perform another transfer
after a successful partial transfer.
-10882
daqPollDataLossError
The data collected on the Remote
SCXI unit was overwritten before it
could be transferred to the buffer in the
host. Try using a slower data
acquisition rate if possible.
-10883
wfmPollDataLossError
New data could not be transferred to
the waveform buffer of the Remote
SCXI unit to keep up with the
waveform update rate. Try using a
slower waveform update rate if
possible.
-10884
pretrigReorderError
Could not rearrange data after a
pretrigger acquisition completed.
-10920
gpctrDataLossErr
One or more data points may have
been lost during buffered GPCTR
operations due to speed limitations of
your system.
-10940
chassisResponseTimeoutError
No response was received from the
Remote SCXI unit within the specified
time limit.
-10941
reprogrammingFailedError
Reprogramming the Remote SCXI unit
was unsuccessful. Please try again.
-10942
invalidResetSignatureError
An invalid reset signature was sent
from the host to the Remote SCXI
unit.
-2001
ERR_TASK_NOT_FOUND
Unable to find task.
-2002
ERR_WORKSHEET_DOES_NOT_EXIST
The worksheet that is specified in the
task's configuration does not exist.
-2003
ERR_RANGE_IS_NOT_VALID
The range that is specified in the task's
configuration is not valid.
