![background image](http://html1.mh-extra.com/html/national-instruments/daqcard-dio-24/daqcard-dio-24_user-manual_709163018.webp)
Chapter 1
Introduction
DAQCard-DIO-24 User Manual
1-6
©
National Instruments Corporation
Custom Cables
The DAQCard-DIO-24 I/O connector is a 25-pin female PC Card I/O
connector. The manufacturer part number National Instruments uses for
this connector is as follows:
•
Elco Corporation (part number 21 5098 0004 00 001)
The mating connector for the DAQCard-DIO-24 is a 25-position male
PC Card I/O connector. The recommended manufacturer part number
for this mating connector is as follows:
•
Elco Corporation (part number 32 5098 0003 00 001)
The cable (26-conductor, 30 AWG, stranded, twisted pair, shielded)
that can be used with these connectors is as follows:
•
Madison Corporation (part number 10482)
The 50-pin connector on the optional PSH27-50F-D1 cable available
for the DAQCard-DIO-24 is a 50-position female polarized ribbon
socket connector with strain relief. The manufacturer part numbers
National Instruments uses for this header are as follows:
•
3M/Electronic Products Division (part number 3425-H650;
strain relief part number 3448-3050)
•
AMP Corporation (part number 1-746288-0; strain relief part
number 499252-4)
The mating connector for the 50-pin socket is a 50-pin male ribbon
cable header. National Instruments uses a polarized (keyed) connector
to prevent inadvertent upside-down connection to the
DAQCard-DIO-24. Recommended manufacturer part numbers for this
mating connector are as follows:
•
3M/Electronic Products Division (part number 3433-6302)
•
Berg Corporation (part number 71912-150)