cRIO-9012/9014 Operating Instructions and Specifications
10
ni.com
NO APP Switch
Push the NO APP switch to the ON position to prevent a LabVIEW startup
application from running on the controller when the controller powers on.
If you want to permanently disable the application from running when
the controller powers on, you must disable it in LabVIEW. To run an
application when the controller powers on, push the NO APP switch to
the OFF position, create an application using the LabVIEW Application
Builder, and configure the application in LabVIEW to launch when the
controller powers on. If you already have an application configured to
launch when the controller powers on and you push the NO APP switch
from ON to OFF, the startup application is automatically enabled. For more
information about automatically launching VIs when the controller powers
on and disabling VIs from launching when the controller powers on, refer
to the
LabVIEW Help
.
USER1 Switch
You can define the USER1 switch for your application. To define the
purpose of this switch in your embedded application, use the RT Read
Switch VI in your LabVIEW RT embedded VI. For more information
about the RT Read Switch VI, refer to the
LabVIEW Help
.
Using the Reset Button
Pressing the Reset button resets the controller in the same manner as
cycling power.
Understanding LED Indications
Figure 7.
CompactRIO Controller LEDs
POWER LED
The POWER
LED is lit while the controller
is powered on. This LED
indicates that the power supply connected to the controller
is adequate,
and that the controller
is supplying power to the CompactRIO system.
1
POWER
2
FPGA
3
STATUS
4
USER1
1
2
3
4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
