cRIO-FRC Operating Instructions and Specifications
16
ni.com
3.
Move the IP RESET switch to the OFF position.
The network settings are restored. You can reconfigure the settings using
the cRIO-FRC Imaging Utility from a computer on the same subnet.
Note
If the chassis is restored to the factory network settings, the LabVIEW Run-Time
Engine does not load. You must reconfigure the network settings and restart the chassis for
the LabVIEW Run-Time Engine to load.
Specifications
The following specifications are typical for the –20 to 55 °C operating
temperature range unless otherwise noted.
Network
Network interface ...................................10BaseT and 100BaseTX
Ethernet
Compatibility ..........................................IEEE 802.3
Communication rates ..............................10 Mbps, 100 Mbps,
auto-negotiated
imum cabling distance ............................100 m/segment
RS-232 Serial Port
Maximum baud rate................................115,200 bps
Data bits ..................................................5, 6, 7, 8
Stop bits ..................................................1, 2
Parity.......................................................Odd, Even, Mark, Space
Flow control............................................RTS/CTS, XON/XOFF,
DTR/DSR
Memory
Nonvolatile .............................................128 MB
System memory ......................................64 MB
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com