CompactRIO cRIO-9066/cRIO-9067 Operating Instructions
|
© National Instruments
|
9
Caution
Ensure that no I/O modules are in the chassis before removing it from the
surface.
Mounting the Chassis on a DIN Rail
You can use the NI 9915 DIN rail mounting kit, part number 779018-01, to mount the chassis
on a standard 35-mm DIN rail. Complete the following steps to mount the chassis on a DIN rail.
1.
Fasten the DIN rail clip to the chassis
using a number 2 Phillips screwdriver and
two M4
×
25 flathead screws, as shown in Figure 9. National Instruments provides these
screws with the DIN rail mounting kit. Tighten the screws to a maximum torque of
1.3 N · m (11.5 lb · in.).
Figure 9.
Installing the DIN Rail Clip on the cRIO-906
x
2.
Insert one edge of the DIN rail into the deeper opening of the DIN rail clip, as shown in
Figure 10.
Figure 10.
One Edge of the DIN Rail Inserted in a Clip
1
DIN Rail Clip
2
DIN Rail
3
DIN Rail Spring
3
2
1