CompactRIO cRIO-9066/cRIO-9067 Operating Instructions
|
© National Instruments
|
7
Note
For more information about mounting the chassis in environments with high
shock and vibration, visit
ni.com/info
and enter the Info Code
criomounting
.
The following sections contain instructions for the mounting methods. Before using any of these
mounting methods, record the serial number from the back of the chassis. You will be unable to
read the serial number after you have mounted the chassis.
Caution
Ensure that no I/O modules are in the chassis before mounting it.
Mounting the Chassis Directly on a Flat Surface Using
the Mounting Holes
For environments with high shock and vibration, National Instruments recommends mounting
the chassis directly on a flat, rigid surface using the mounting holes in the chassis. Complete the
following steps to mount the chassis.
1.
Use the dimensions shown in Figure 4 to prepare the surface for mounting the chassis.
2.
Align the chassis on the surface.
3.
Fasten the chassis to the surface using three M4 or number 8 screws appropriate for the
surface, as shown in Figure 6. Screws must be longer than 19 mm (0.75 in.) to pass all the
way through the chassis. National Instruments does not provide these screws with the
chassis.
Figure 6.
Mounting the cRIO-906
x
Directly on a Flat Surface
