NI CB-37F-LP Installation Guide
6
ni.com
Cabling the Connector Block to the Device
If you do not mount the connector block to the PCI device, you must use a
cable to connect the CB-37F-LP to the device. Refer to Figure 4 as you
complete the following steps to connect the connector block to the PCI
device I/O connector.
Figure 4.
Connecting the CB-37F-LP to a 37-Pin Device with a Cable
Caution
The connectors of both the PCI device and the connector block are polarized.
You can attach them in only one way. Do
not
force the cable when inserting it into or
removing it from the PCI device I/O connector or the CB-37F-LP. Make sure that the
computer is powered off before inserting the PCI device.
1.
Install the PCI device into the computer as described in the
DAQ Quick
Start Guide
. You must make the connection between the CB-37F-LP
and PCI device
after
the device is installed in the computer.
2.
Connect the SH37F-37M cable to the PCI device I/O connector.
3.
Connect the other end of the cable to the CB-37F-LP connector.
1
CB-37F-LP
2
SH37F-37M Cable
3
37-Pin NI Device
4
Computer
1
2
4
3
