![background image](http://html1.mh-extra.com/html/national-instruments/cb-37f-lp/cb-37f-lp_installation-manual_3401866007.webp)
©
National Instruments Corporation
7
NI CB-37F-LP Installation Guide
Caution
The CB-37F-LP is not designed for input voltages greater than 42 V
pk
, even if you
install a voltage divider that reduces the voltage to within the input range of the DAQ
device. Input voltages greater than 42 V
pk
can damage the CB-37F-LP, any device
connected to it, and the host computer. Overvoltage also can cause an electric shock hazard
for the operator. National Instruments is
not
liable for damage or injury resulting from such
misuse.
Specifications
This section lists the specifications of the CB-37F-LP. These specifications
are typical at 25 °C unless otherwise specified.
Input/Output
Refer to the documentation for your NI PCI-6010 device to determine the
input/output specifications for your application.
Physical
Dimensions............................................. 5.733
×
8.113
×
1.417 cm
(2.257
×
3.194
×
0.558 in.)
I/O connector.......................................... One 37-pin female D-Sub
connector
Screw terminals
Number ........................................... 40
Type ................................................ Angled entry, 3.91 mm pitch
Environment
Operating temperature............................ 0 to 55 °C
Storage temperature ............................... –20 to 70 °C
Relative humidity ................................... 10 to 90% noncondensing
Pollution Degree .................................... 2
Altitude................................................... 2,000 m
Indoor use only.