![background image](http://html.mh-extra.com/html/national-instruments-corporation/scxi-1162/scxi-1162_user-manual_710253076.webp)
SCXI-1162 Cabling
Appendix E
SCXI-1162 User Manual
E-8
© National Instruments Corporation
(continues)
Table E-4. SCXI-1162, DIO-96, AT-MIO-16D, and AT-MIO-64F-5 Pinout Equivalences
(Continued)
Pin
SCXI-1162 Rear Signal
Connector
DIO-96
Board
Equivalent
AT-MIO-16D
AT-MIO-64F-5
(pins 1-50
Serial
Parallel
only)
25, 75
SERDATIN
(pin 25 only)
Out (11)
APB3, CPB3
ADIO0
ADIO0
26
SERDATOUT (MIO)
BDIO0
BDIO0
27, 77
DAQD*/A
(pin 27 only)
Out (10)
APB2, CPB2
ADIO1, PB2
ADIO1
29, 79
SLOT0SEL*
(pin 29 only)
Out (9)
APB1, CPB1
ADIO2, PB1
ADIO2
31, 81
SERCLK (DIO)
(pin 31 only)
Out (8)
APB0, CPB0
PB0
33, 83
Out (7)
APA7, CPA7
PA7
34, 84
Out (31)
BPA7, DPA7
35, 85
Out (6)
APA6, CPA6
PA6
36, 86
Out (30)
BPA6, DPA6
37, 87
SERCLK (MIO)
(pin 37 only)
Out (5)
APA5, CPA5
EXTSTROBE*,
PA5
EXTSTROBE*
38, 88
Out (29)
BPA5, DPA5
39, 89
Out (4)
APA4, CPA4
PA4
40, 90
Out (28)
BPA4, DPA4
41, 91
Out (3)
APA3, CPA3
PA3
42, 92
Out (27)
BPA3, DPA3
43, 93
Out (2)
APA2, CPA2
PA2
44, 94
Out (26)
BPA2, DPA2
45, 95
Out (1)
APA1, CPA1
PA1
46, 96
Out (25)
BPA1, DPA1
47, 97
SERDATOUT (DIO)
(pin 47 only)
Out (0)
APA0, CPA0
PA0
48, 98
Out (24)
BPA0, DPA0
50, 100 DIG GND (DIO)
GND
GND
GND
No other pins are connected on the SCXI-1162.
SCXI-1351 and NB5 Cable Installation
Follow these steps to install the SCXI-1351:
1. Make sure that the computer and the SCXI chassis are turned off.
2. Install the SCXI module in the chassis.
3. Connect either the position 1 through 50 connector or the position 51 through 100 connector
of the NB5 cable to the male breakout connector on the SCXI-1351.