National Flooring Equipment DL6000P, Operating & Service Manual

Page: 16 / 52

16
Installation
WARNING:
ALWAYS TRANSPORT THE MACHINE IN THE LOWERED POSITION.
406816_RevB
WARNING:
BEFORE INSTALLING THE DUST COLLECTOR, CAREFULLY MAKE A SIGHT CHECK TO PINPOINT ANY DAMAGE SUFFERED
DURING TRANSPORT.
In the event of an extension cord being used, make sure this is in perfect condition, in compliance with Ce standards and with cable cross
section suitable for the power input of the dust collector.
1. Raise the dust collector to working height
• In order to raise the dust collector easily, NFe suggests removing the motor head.
• Pull the pins on each side of the dust collector one at a time and turn them until they are in the locked position.
•
Lift the machine body using the handle.
•
Lock the machine body turning the pins to their initial position.
•
If movement becomes difficult, remove the side cover, loosen the screws and if necessary, put some grease on the sliding system.
• To lower the dust collector, reverse the above steps.
2.
Attach the Y-hose adapter.
3. Attach an elbow connector to the inlet adapter of each dust collector.