Magna-Matic Corporation - W4599 County Road IW - Waldo WI 53093 USA - Phone: (920) 564-2366 - FAX: (920) 564-2368 - Toll Free USA & Canada
1-800-328-1110
http://
www.magna-matic.com
- email: [email protected] © Copyright 2023 All rights reserved
MAG-200 Dust Collector Set-up
1. Install inlet flange on top of dust collector.
2. Ensure the ON/OFF switch is in the OFF position (red switch cover closed)
3. Plug in to 110v 60hz outlet
4. Turn on MAG-200 to test
ORIGINAL INSTRUCTIONS for MAG-200 Series Dust Collector
Generation 2 (October 16,2017 to present)
Cleaning of the MAG-200
1. Remove the yellow bottom cover by unlatching the two catch clamps.
2. The bottom cover collects the grit and dust. Dispose of the grit and dust, then
wipe out the bottom cover. Inspect seals in bottom cover, replace if damaged.
3. Pull the aluminum mesh filter out of the MAG-200. This filter is cleanable, the grit
and dust can be shaken out of this filter. When it is clean, place it back inside of the
MAG-200 as shown to the right. The filter sits at an angle inside the MAG-200 to
block all incoming large grit and sparks from reaching the other filters.
4. Install the yellow bottom cover back onto the MAG-200.
Pleated 3rd Stage Filter Replacement
1. The 3rd stage filter cover of the MAG-200 must be removed to access filters.
2. Remove the three screws to remove the cover. (You may purchase optional yellow thumb
screws at magna-matic.com if you would like tool-less access.)
3. Pull the pleated filter out of the cover - discard and replace with part 200-17 filter.
4. Replace with a new pleated filter ensure air flow direction arrow it is in the correct direction.
5. Gently push the pleated filter into the 3rd stage filter cover and ensure it is seated.
Pad Filter Replacement
6. Remove the four screws and pad filter cover. (Replace with thumb screws if you desire for
tool-less access, available at magna-matic.com)
7. Pull the pad filter out and replace with part 200-15
8. Ensure the white surface is pointed outward and the green surface inward when installing
new pad filter.
200-17
Pad filter
cover
Foam seal
3rd stage
filter cover
WARNING
NEVER ALTERNATE A MAG-200
BETWEEN A SHARPENER AND THE
MAG-12008 BLADE CLEANER
SPARKS MAY IGNITE GRASS AND
DEBRIS GENERATED BY THE
MAG-12008 BLADE CLEANER
DANGER
RISK OF FIRE. PART 200-70 SPARK
ARRESTOR IS REQUIRED FOR HIGH
SPARK LOAD APPLICATIONS.
ALWAYS INSPECT DUST COLLECTOR
AFTER USE. DO NOT USE WITH
COMBUSTIBLE MATERIALS
Filter
Replacment
Video
Buy Filters
200-20-KIT
Install Video
MAG-10400
Stand
Assembly
Support Videos and Links for the MAG-200 Dust Collector
