National Flooring Equipment DL6000P, Operating & Service Manual

Page: 27 / 52

27
Troubleshooting Guide - Dust Collector
FAULT FOUND POSSIBLE CAUSE RECOMMENDED REMEDY
The dust collector fails to start
No power
Check the power mains supply. Check the
integrity of the plug and power cable.
Main circuit breaker tripped Reset breaker (in power box)
Thermal magnetic switch tripped Reset the thermal magnetic switch
Dust is leaking out
Perforated vacuum hose Replace the hose
Perforated filter Replace the filter
Filter unsuitable for type of job
Use a suitable filter for the type of material to
be vacuumed
The dust collector does not work as it should
Hose perforated or blocked Check the hose and, if necessary, replace it
Longopac® bag is full
Replace bag
Filter blocked
Perform filter cleaning cycle and, if
necessary, replace filter
Longopac flap not closing
Contact NFe technical support
Seals worn
Check the seals and, if necessary, replace
them
Air leak
Check for any air leaks out of closing
fasteners, tightening screws, Longopac® bag
or filter chamber
Motor very noisy Contact NFe technical support
IMPORTANT!
FOR ANY OTHER PROBLEMS, CONTACT THE NFE TECHNICAL SUPPORT.
406816_RevB