National Flooring Equipment 8000, Manual, Page: 25 / 68

Machine Maintenance
25
REPLACE IN-TANK STRAINERS
1. Remove the (8) socket head cap screws that hold down the top suction assembly.
2. Carefully pull the suction assembly out as far as you can.
3. Reach in to the reservoir and unscrew the strainers from the end of the suction hose.
4. Screw in the replacement strainers to the end of the suction hose.
5. Re-assemble the suction assembly by re-seating the assembly and tightening down with the (8) socket head cap screws.
HYDRAULIC CYLINDER CHANGE OUT
1. Disconnect machine from power.
2. Disconnect cylinder lines. Have a container or rag ready to catch oil from lines.
3. Remove cylinder securing hexhead bolt from lower cutting head support.
4. Remove clips and pin from cylinder and slide plate.
5. Remove cylinder upper pin.
6. Remove
cylinder.
ENGINE CHANGE OUT
1. Disconnect motor from power.
2. Lift hood and secure in place.
3. Remove cap from engine oil hose. Drain.
4. Remove engine oil
fi lter.
5. Replace cap & new fi lter. Re fi ll with new engine oil.
TO REMOVE OR CHANGE A HOSE
To remove or change a hose
1. Disconnect machine from power.
2. Remove
hood.
3. Using proper wrench size, remove hose from fi tting.
4. When replacing, make sure O-ring is properly seated on hose fi tting.
TO REMOVE OR REPLACE FOOT PEG
To remove or replace foot peg
1. Insert a socket with extension into foot peg and secure bolt head with wrench.
2. Remove nut from inside of peg.
3. Remove foot peg from bolt.
4. Replace foot peg before operating machine. DO NOT use machine without foot pegs.
Fax: 763-535-8255 info@nationalequipment.com