Machine Maintenance
DUAL SLIDE PLATE REMOVAL
1. Lower the slide plate to the
fl
oor and place a block under the assembly.
2. Remove the front cylinder by taking the 1/2” bolt out of the bottom and removing the
pin from the top of the cylinder.
3. Remove the E-clips from the pin at the bottom of the internal cylinder, then remove
the pin.
4. Remove the pin from the top of the internal cylinder and then remove the cylinder
from the machine.
5. Loosen the pinch bolt from the lower right side of the frame.
6. Remove the lock nut from securing bolts at the top of the slide plate.
7. Remove the socket head screws at the top of the dual slide from both sides of the
assembly.
8. Install 3/8-16x5” bolts into the holes the socket head screws were removed from.
Once installed the bolts should be used as lifting handles.
9. Lift the frame out of the machine.
LEAK MAINTENANCE
All
fi
ttings on this machine are O-ring style.
1. Disconnect machine from power.
2. If a leak is detected, tighten
fi
tting with the proper wrench size. DO NOT over
tighten. Over tightening could damage O-rings.
3. If a leak still persists, remove
fi
tting and replace O-ring.
HYDRAULIC FLUID LEVEL
To check hydraulic
fl
uid
1. Remove breather dip stick (See Figure SS)
2. Check to see that hydraulic
fl
uid is visible on dip stick
OR
1. Remove
fi
ller plug (See Figure TT).
2. Oil should be visual 5 cm (2”) below hole (use
fl
ashlight to illuminate).
3. Reinsert
plug.
HYDRAULIC OIL CHANGE OUT
1. Let
hydraulic
fl
uid cool before maintenance.
2. Disconnect machine from battery.
3. Drain
fl
uid by removing the drain plug from side of tank (See Figure TT). Take Cau-
tion: this unit contains seven gallons of
fl
uid. Make sure you have the proper size
containers to catch
fl
uid.
4. Replace drain plug.
5. Remove
fi
ller plug (See Figure TT).
6. Add oil into the
fi
ller plug hole until visual 5 cm (2”) below hole.
24
FIG. TT
Filler Plug
Drain Plug
FIG. SS
Breather
Dip Stick
www.nationalequipment.com
Phone: 763-315-5300
CAUTION:
LET ENGINE COOL BEFORE ANY MAINTENANCE. FAILURE TO DO
SO COULD CAUSE SERIOUS BODILY INJURY.
Summary of Contents for 8000
