National Cycle, Inc.
PO Box 158 Maywood, IL 60153-0158 USA
P: 708-343-0400 / F: 708-343-0625 / E: [email protected]
www.nationalcycle.com
©2021 National Cycle, Inc.
Page 06 of 13
10-118625-000 03/21
Figure 20
PREPARATION AND ELECTRICAL WIRING; CONT’D.
Figure 20
Locate the end of the Wire Harness that terminates in a Brass Open Ring
Connector
(V)
as shown. Loosen the positive terminal nut of the vehicle’s
battery with a Philips screwdriver or 10mm wrench.
Figure 21
Slip the Brass Open Ring Connector under the positive terminal nut and
then tighten securely.
Figure 22
Use a Wire-Tie
(M)
to organize and secure any slack coils of the Wire
Harness and...
Figure 23
...stow the excess coils under the left front wheel cover inside the engine
compartment.
Figure 24
Close the vehicle’s engine cover because you are finished with the
PREPARATION AND ELECTRICAL WIRING
step.
Now it's time for a refreshing beverage.
Figure 21
Figure 22
Figure 23
Figure 24
