National Cycle, Inc.
PO Box 158 Maywood, IL 60153-0158 USA
P: 708-343-0400 / F: 708-343-0625 / E: [email protected]
www.nationalcycle.com
©2021 National Cycle, Inc.
Page 10 of 13
10-118625-000 03/21
Figure 37
Figure 38
Figure 35
Terminal I
Fluid Hose
TERMINAL CONNECTIONS TO WIPER MOTOR
Figure 35
Check that the Wiper Arm Fluid Hose is threaded through the Grommet in
the Windshield to the inside of the cabin. If it is not, do this now.
Figure 36
Connect the Wiper Arm Fluid Hose to the fluid hose from Motor Hose/Fluid
Connector terminal
(I)
with the Inline Check Valve
(E)
. A little moisture on
the Check Valve ends will make the hoses join easier.
The arrow on the Inline Check Valve
(E)
must point towards the Wiper
Motor, not towards the Fluid Reservoir.
Figure 37
Join the power connectors from the Wiper Motor and from Motor
Connector/Fluid Hose terminal (I).
Tuck excess wiring behind the Wiper Motor assembly.
Figure 38
The completed Wiper Motor installation should appear as shown.
FILL THE FLUID RESERVOIR
Fill the Reservoir (I) with plain water during warm weather, and glycol-
based automotive windshield washer fluid in freezing weather.
DO NOT run the pump dry. Minimum amount
of fluid to maintain in the Reservoir is 12 oz.
(.35L) or to a depth of 1-1/2" (38mm).
Figure 36
Minimum Depth: 1-1/2
"
