Page 16
Natcomm
PROGRAMMING PROCEDURE
Please refer to the comments on pages 14-15
1.
CONNECT A STANDARD TELEPHONE
(or Test Phone)
TO THE PROGRAM PORT OF YOUR DS5 UNIT
2.
TURN OFF POWER TO YOUR DS5 UNIT
3.
SWITCH ON POWER AND PRESS #
(within 30 seconds)
You must use the telephone connected to the DS5 program port.
4.
YOUR UNIT WILL OUTPUT 3 SHORT ‘BEEPS’
Do not proceed until you have heard 3 short beeps. If you do not hear 3
beeps, return to the start (1).
5.
ENTER PROGRAMMING COMMANDS AS FOLLOWS:
You can change parameters in any order. 1 short ‘beep’ indicates a correct
entry. 1 long ‘beep’ is an incorrect entry. Try again.
A.
DOOR PHONE CALL ADVICE TONES
To disable TONES press #40. To enable TONES press #41
B.
MAXIMUM DOOR PHONE CALL TIME
To enter the MAX CALL TIME press #3xx
x = time limit in seconds and can be 15-99
Note - if needed, you can increase the max call time by a factor of 10 by
adding a * before your numeric entry of 15-99.
Ie; to set 500 seconds, you can enter #3*50
C.
LOCK ACTIVATE TIME
To enter the LOCK ACTIVATE TIME press #6xx
xx = time limit in seconds and can be 01-99
(for example, press #620 for 20 seconds)
TO EXIT PROGRAMMING MODE - HANG UP.
ALL ENTRIES ARE SAVED IN PERMANENT MEMORY.