Page 12
Natcomm
TESTING THE DOOR PHONE
You are now ready to test the DOOR PHONE connection by pressing the Call
Button on the Door Phone.
Your PBX or other Multi-Line telephone system should now connect the DOOR
PHONE call to the correct destination. Have someone answer the call to
communicate.
Note - The Destination telephone must be located at least 10ft from the Door
Phone, or you may only have communication in 1 direction. If you are using a
Cordless Phone or Cell Phone, you may need to walk away until communication
in both directions is achieved.
Once you hang up, DS5 should disconnect the call after detection of 3 ‘Hang Up
tones’.
If the AUDIO Connection is not clear in both directions, you will need to adjust
the Balance Pot, as described on page 13.
TROUBLE SHOOTING
If your Phone System does not respond when you have pressed the Call Button on
the Door Phone, then you should:
•
Open the supplied Interface Unit and temporarily short across the internal screw
terminals connected to the RED and GREEN wires.
•
If the Phone System does not respond, it may not be programmed correctly.
•
You should remove DS5 from the Analogue extension and connect an Analogue
telephone or test phone in its place. You should only fit DS5 back on the Analogue
extension once an ‘off hook’ by your Analogue telephone or test phone causes
your telephone system to respond correctly.
•
If the Phone System responds correctly, then there may be a problem with the
cabling from the Door Phone to the interface unit. You should temporarily short
across the center 2 positions of the 4 position Dinkle plug which connects to the
Door Phone (or the 2 screw terminals if you are using a DP1). If the Phone system
does not respond, then you have a problem with the cabling back to the DS5 that
must be repaired or replaced. If the Phone system does respond, then you may
have a problem with the Door Phone. Call
07 5596 5128
for assistance
.