Natcomm
Page 15
PROGRAMMING NOTES
1)
To program your unit, you need to temporarily connect a standard Analogue
Telephoned (or a Test Phone) to the PROGRAM PORT of your DS5 unit. All
entries must be made using this telephone.
2)
The PBX EXTENSION port of your DS5 unit MUST be connected to a
telephone extension (or you can alternatively use a normal PSTN line). This is
so a telephone line ‘battery feed’ can be connected to the Programming
Telephone, which will allow the attached Phone to generate touch tones.
3)
To enter PROGRAMMING MODE you must turn OFF POWER to your unit and
then switch POWER ON AGAIN.
4)
You must PRESS # within 30 SECONDS of reconnecting power.
You will hear 3 short ‘beeps’ to confirm you are in programming mode.
5)
Individual Parameter Programming Entries (A-C) are then carried out by
pressing further keys on the attached telephone (see below).
Note
- Parameters can be changed in any order.
Note
- After each entry, DS5 should generate 1 short ‘beep’ to confirm acceptance
of command, or 1 long ‘beep’ to advise of an entry error. If 1 long ‘beep’ is detected,
your command should be repeated.
A.
DOOR PHONE CALL ADVICE TONES
To disable TONES press #40
To enable TONES press #41
B.
MAXIMUM DOOR PHONE CALL TIME
To enter the MAX CALL TIME press #3xx
x = time limit in seconds and can be 15-99
Note - if needed, you can increase the max call time by a factor of 10 by adding a *
before your numeric entry of 15-99.
Ie; to set 500 seconds, you can enter #3*50
C.
LOCK ACTIVATE TIME
To enter the LOCK ACTIVATE TIME press #6xx
xx = time limit in seconds and can be 01-99
(for example, press #620 for 20 seconds)