National Communications
Page 13
PROGRAMMING PROCEDURE
You need to connect a standard analogue telephone (or telephone
buttinski) to the LINE OUT port of
AAD
2 and then follow the procedure
below :
1. TURN OFF POWER TO YOUR UNIT
2. SWITCH ON POWER AND PRESS # on the attached telephone
3. YOUR UNIT WILL OUTPUT 3 SHORT ‘BEEPS’
Do not proceed until you have heard 3 short beeps.
If you do not hear 3 beeps, return to the start.
4.
ENTER OPERATING MODE REQUIRED
For MODE 1 operation enter #10
For MODE 2 operation enter #11
For MODE 3 operation enter #12
You will hear 1 beep if entry is accepted.
Do not proceed until after confimation beep
HANG UP IF PROGRAMMING IS COMPLETE
OR PROCEED TO CHANGE OTHER PARAMETERS IF REQUIRED
5.
RING COUNT BEFORE ANSWER
To enter the NUMBER OF RINGS press #2xx
where xx = number of rings and can be 01-19
To Answer in 2 rings, press #202 (Default)
To Answer in 8 rings, press #208
Please wait for confirmation beep before proceeding.
