Page 12
National Communications
PROGRAMMING OVERVIEW
All Programming SETTINGS are stored in non volatile flash memory
and will be retained even if power is disconnected.
AAD
must be in PROGRAMMING MODE in order to change settings or
add Dial Numbers.
AAD
is programmed by DTMF Touch Tones.
You need to connect a standard analogue telephone (or telephone
buttinski) to the LINE OUT port of
AAD
to enter the DTMF Touch Tones.
There are 3 separate Programming Areas :
1. SET OPERATING MODE
You MUST enter the required OPERATING MODE.
See page 11 for instructions.
2. CHANGE THE OTHER PARAMETERS
In most cases the default ANSWER and other SETTINGS of this
device will be suitable for your requirements and programming
will not be necessary.
However if required, you can change any of the
following USER
PROGRAMMABLE SETTINGS to meet individual telephone
system requirements.
