INTELLIREAM
®
MP
pg.
29
8.6.
Air Motor Replacement
• Disconnect air and electrical supply.
• Open back door,
item 1
.
• Disconnect hoses 141 and 142,
item 2
, from the motor.
Check and note the belt tension,
item 3
.
• Hold the motor from below and remove two 6mm
hex head bolts,
item 4
. (10mm wrench)
• Slip belt off motor pulley and remove motor,
item 5
.
• Insert new motor into mount.
• Follow steps in reverse order to reassemble
Intelliream
®
.
• Apply medium strength thread locker to
item 4
.
8.7.
Motor/Lift/Clamp Solenoid Replacement
Note: The right solenoid is for the motor, the middle
solenoid is for the lift cylinder, and the left solenoid is
for the clamp cylinder. Similar procedures are used
for each solenoid.
• Disconnect air and electrical supply.
• Open back door,
item 1
.
• Remove electrical connector,
item 2
, from
corresponding solenoid.
• Remove two M3 socket head cap screws,
item 3
,
from solenoid. (2.5mm hex drive)
• Remove and replace solenoid,
item 4
.
• Follow steps in reverse order to reassemble
Intelliream
®
.
1
2
3
4
5
1
4
3
2
