INTELLIREAM
®
MP
pg.
28
8.5.
Clamp Cylinder Replacement
• Disconnect air and electrical supply.
• Open back door,
item 1
.
• Remove five socket head cap screws,
item 2
, and
TCP check pin to remove top lid,
item 3
. (3/16” hex
drive)
• Disconnect hose 121 and 122,
item 4
, from cylinder ports.
(see page 29)
• Remove reed switch,
item 5
, from cylinder. Flat
Head Screwdriver)
• If wire cutter option is installed, remove two #10-24
flat head socket cap screws,
item 6
, to remove
wedge plate. (1/8” hex drive)
• Unfasten cylinder rod,
item 7
, from T-nut,
item 8
.
(3/8” wrench)
• Loosen and remove cylinder nut,
item 9
. (1 1/8”
wrench)
• Remove and replace cylinder,
item 10
.
• Follow steps in reverse order to reassemble
Intelliream
®
.
• Apply medium strength thread locker to
item 6, 7,
and 9
.
• Check the position of the reed switch,
item 5
. The
LED should be on when the clamp is open with the
electrical supply connected.
2
3
6
1
4
5
10
7
8
9
