INTELLIREAM
®
MP
pg.
19
5.4.
Running Mode
Several running modes are available to select from.
Automatic:
Every aspect of the cycle is commanded, monitored, and checked by the control module.
Dry Run:
The motor and fluid solenoid are disabled.
Timed:
Bypass the "extended" sensor on the lift cylinder. The robot must hold the start signal on for the
reaming time. Auto Retry is disabled in this and the following modes.
Open:
Bypass the "extended" and "retracted" sensor. The robot must hold the start signal on for the reaming
time and hold the robot in the clamp until the reaming bit is fully retracted.
Blind:
Bypass all sensors. The robot must hold the start signal on for the ream time and hold the torch in the
jaws until the reaming bit is fully retracted and the clamp is fully opened.
Mode configuration:
A specific running mode can be configured by the following procedure.
Follow the steps outlined above to access the mode configuration menu. Upon releasing the settings button,
the LEDs will flash green on top and bottom. This is the first in the sequence of teachable configurations.
Subsequent pressing and releasing of the settings button will sequence the following configurations in order of
appearance. To register the desired configuration, press the reset button when that configuration is displayed.
Mode
Mode
Automatic
Dry Run
Timed
Open
Blind
Auto
Clamp
status
Lift
status
Done
G
Y
G
G
R
G
R/G
G
G
G
Y
R
R
G
R/G
Press &
Release
(>9sec)
