HUOM! Ohjausyksikköä ei saa
asentaa seinäsyvennykseen.
Kuva 5.
Kuva 2
10cm
min. 60cm
M
ax. 90cm
3. INSTALLATION:
3.1 Installation instructions for the heater, the temperature sensor and the control unit
- Connection of the sauna heater to the power supply may only be carried out by an
authorised electrician in accordance with the valid regulations.
- A rubber-sheathed cable of type H07RN-F or similar must be used as the connection cable.
- If you want to make use of the temperature control feature, we recommend using a rubber cable
with at least seven wires. The cross-section of the cable and the fuse size are presented in Table 1.
3.11 Connection the power supply cable
- Lay the sauna heater on the floor, with its front facing the floor
- Remove the bottom plate
- Connect the power cable
3.12 Installing the temperature sensor
- Install the sensor in the area lined in Figure 2.
- Install the temperature sensor on the wall with
the screws included in the delivery
(2 pcs. Ø 2,9 x 16).
- The wiring for the temperature sensor can
be embedded.
- Connect the sensor to the circuit plate,
as shown in Fig. 2.1.
- Connect the end of the conductor, the one with
no connector in place, to the temperature sensor.
You can cut the conductor to a suitable length.
- See 6. Air exchange for the steam room
Figure 1. Minimal safety clearances for the
VELVET
heater.
The installation of
a heater in a wall
recess
Figure 2.
3.13 Installing the control unit
- The control unit can be installed inside or
outside the steam room. The control unit is
moisture-proof, so it can be installed in the
wash room.
- The installation height of the control unit is
a maximum of 90 cm and a minimum of 60 cm
from the side of the heater (see Fig. 3).
- Attach the control unit to the wall using
screws (2 x 3.5 *15).
- Connect the control unit to the circuit plate,
as shown in Fig. 2.1.
- The control unit cable is 3.0 metres long.
- A cable of maximum length 10 metres is available
by special order. The excess cable must not be
inserted into the heater’s connecting box.
min. 60cm
M
ax. 90cm
HUOM! Ohjausyksikköä ei saa
asentaa seinäsyvennykseen.
Kuva 5.
10cm
Kuva 4
5cm
5cm
Fastening of the control unit
to the wall. ATTENTION!
The control unit must
not be installed in a wall
recess.
Figure 3.
D min
A min
B min
C min
A min
A min
max 30 cm
Figure
2.1
Connection of circuit board
Socket for the
control unit
The locking lever
on the outer edge
side!
Socket for the
temperature
sensor
