![background image](http://html1.mh-extra.com/html/narvi/velvet-electric-6-8kw/velvet-electric-6-8kw_installation-and-instruction-manual_3356057017.webp)
INSTALLATION AND OPERATING
INSTRUCTIONS
NARVI VELVET ELECTRIC
6,8kW
102430
NARVI VELVET ELECTRIC
9kW
102432
NARVI VELVET ELECTRIC
10,5kW
102434
GB
1. THE ELECTRIC HEATER SET INCLUDES:
1. Heater with control unit
2. Fastening plates and fastening screws
3. Temperature sensor
4. Control unit
5. Installation and operating instructions
2. BEFORE INSTALLATION:
Check on the following:
– Make sure the capacity of the heater (kW) corresponds to the size of the steam room (m
3
).
– Table 1 shows the heater types that correspond to various size saunas.
– If the steam room has any non-insulated brick, tile or glass surfaces, 1.5 m
3
of
space must be added to the size of the steam room for every square-meter of such
surfaces. Based on the result, choose the heater with the required capacity shown
in table 1.
When choosing a heater, strictly adhere to the steam room space shown in table 1.
Table 1. Installation information for VELVET heaters
– The minimum height of the steam room and minimal safety clearances are
shown in table 1.
– Make sure that the surface onto which the fastening plates are being screwed is
sufficiently strong. Thin boarding is not sufficient. The surface can be reinforced with
a supporting framework under the boarding or reinforcing boards on top of the wall,
which is connected to a wall framework.
– The heater can also be installed into a wall recess, see figure 1.
ONLY ONE ELECTRIC HEATER MAY BE INSTALLED IN EACH SAUNA ROOM.
Heater model
Capacity
Sauna room
Minimal safety clearances to the heater
Quantity
of stones
Connection *)
Volume
Height
on the
sides
at the
front
to the ceiling
to the floor
400 V
3N
Fuses
min max
min
A **)
B **)
C **)
D **)
kW
m
3
m
3
cm
cm
cm
cm
cm
kg
mm
2
A
102430
6,8
5
8
190
12
12
75
3
140
5x1,5
3x10
102432
9
8
14
190
12
12
75
3
140
5x2,5
3x16
102434
10,5
10
18
210
15
15
95
3
140
5x2,5
3x16
**) See figure 1
*) Connected with rubber cable, type H07RN-F
or corresponding cable
TECHNICAL DATA:
- width 352 mm
- depth 352 mm
- height 1157 mm
- weight 21 kg
(without stones)