4. CONTROL CONSOLE AND MAIN POWER SWITCH:
– The control console is installed in the sauna or dressing room.
– NB! The control console for the 4.5 kW stove cannot be installed in the sauna room.
- In the sauna room, the control console should not be installed higher than 90 cm
or lower than 60 cm next to the stove. (See figure 5).
– Fasten the control console to the wall with screws (2 pc, Ø 3.5 x 15).
The length of wire for the control console is 2 meters long. A wire of up to
10 meters is available as a special order. The wire must not be pushed into the
stove connection switchboard.
– The main power switch is located on the lower section of the front of the stove.
(See figure 6).
Kuva 3
66
Kuva 2
Kuva 3.1
66
Kuva 6
Kuva 3.2
Kuva 3.3
Kuva 3.4
Figure 6.
min. 60cm
M
ax. 90cm
HUOM! Ohjausyksikköä ei saa
asentaa seinäsyvennykseen.
Kuva 5.
10cm
Kuva 4
5cm
5cm
Fastening of the control console
to the wall. ATTENTION! The
control console cannot be
fastened to a wall recess.
Figure 5.
– When piling the stones, make sure that the heating units do not bend and sufficient
air circulation is guaranteed.
– Pile the stones loosely. Stones that are piled too tensely may cause the heating
units to overheat (= shorter life span) and slow down the heating of the sauna.
– Stones with diameters of 4-7 cm are suitable for the stove.
– The front of the stone container must be piled as densely as possible.
The heating units must not be exposed.
– Ceramic stones cannot be used in this stove.
A STONE CONTAINER THAT IS FILLED TOO SPARSELY MAY BE A FIRE HAZARD!
BEFORE PLUGGING IN THE STOVE, INSPECT THE SAUNA ROOM!
4.1. Operating instructions for control console
1. ON/OFF-button
• When the display is off, pushing the button will activate the control console and stove.
The button must be pushed for more than one second.
• A long push (>1 second) will switch off the control console and stove.
• Once the stove is activated, the display shows the pre-selection time
(the yellow LED light is flashing).
The pre-selection time remains on the display for about 5 seconds, thereafter,
the measured temperature appears on the screens (normal state).
• other functions of the ON/OFF-button
(pressure of <1 seconds)
The first push is for regulating the pre-selection time. The yellow LED light flashes.
The second push regulates the time it is turned on. The yellow LED light is burning.
The third push regulates the desired temperature. The green LED light flashes.
The fourth push shows the measured temperature.
1 keltainen
2 punainen
3 vihreä
4 kiuas päälle/pois
5 Läpötilan säätö
1
2
3
4
5
1 yellow
2 red
3 green
4 switching the stove
on and off
5 regulating the temperature
