NARDA SRM-3006, Operating Manual

Page: 189 / 240

16 Remote Control
Narda SRM-3006
177
16.3 Activating / deactivating remote control
To activate remote control:
⇒
Transmit the command
REMOTE ON;
ª
The SRM-3006 switches to remote controlled operation.
ª
The screen display switches off.
ª
The keypad is disabled.
To deactivate remote control:
⇒
Transmit the command
REMOTE OFF;
ª
Remote control is deactivated.
ª
The screen display switches on.
ª
The keypad is enabled.
16.3.1 Solving problems
If the SRM-3006 does not switch to remote controlled operation, check the
following items:
• Has you used the correct remote control cable (zero modem cable) and is
the cable OK?
• Do the interface parameters on the PC and the SRM-3006 match?
• Was the command
REMOTE ON;
transmitted correctly (Response =
0
)?
• Is the SRM-3006 set to the correct interface?
(
Main Menu / Device Settings: Remote Interface
)
16.4 Syntax rules for remote control
commands
16.4.1 Commands to the SRM-3006
The following types of command can be transmitted to the SRM-3006:
•
GET command
: gets information about the actual settings of the
SRM-3006
•
SET command
: changes a setting on the SRM-3006
Remote control syntax is based on ASCII strings. The command interpreter
does not distinguish between upper and lower case characters
(
Command [Parameter_1]; = COMMAND [Parameter_1];
). For clarity,
some commands contain underline characters (e.g.
F_MIN
,
BI_VALUE
).