SignalShark User Manual
80
Configuring the measurement performance
(Config)
Here you can define how measurements are performed.
You selected the desired view.
1.
Tap the
Config
button.
2.
Then you can do the following:
Setting the number of measurements (Scan. No)
Sets the number of measurements for a single run measurement until the measurement
stops. It also affects the longtime detectors (
MxP
,
MxR
, ...).
Changing the parameters:
1.
Tap the button and set the number of measurements either by using the rotary control
knob or by entering the value.
2.
Tap the
OK
button.
3.
Press the
Esc
key or tap the header to close the menu.
Setting the measurement sequence (Seq Mode)
Here you can set the following:
•
Single
: Measurement stops after the number of scan count is reached.
•
Conti
: Continuous measurement.
To change the parameters:
1.
Tap the toggle button to select
Single
or
Conti
.
2.
Press the
Esc
key or tap the header to close the menu.
Defining the stop behavior (Stop Mode)
The stop mode value changes the behavior of the measurement engine, after the
Run
key is
pressed.
•
Hold
: Measurement continues in the background.
•
Stop
: Measurement stops and runs again.
You can stop/hold the measurement using the
Run
key.
