SignalShark User Manual
12
Figure:
Control connector (1), N-connector (2)
To connect the handle:
1.
Plug the control cable plug of the handle into the control connector socket on the device
(1)
, making sure that the red mark on the control cable plug is aligned with the notch on
the control connector socket.
2.
Press the control cable plug into the control connector socket using the locking sleeve
until the plug lock clicks into place.
3.
Place the N-connector of the handle into the N-connector of the basic unit
(2)
and tighten
the coupling nut slowly and without tilting.
Connecting the antenna to the handle
Narda directional antennas can be attached to the handle in positions that are at angles of 90
degrees to each other. This makes it quick and easy for you to change the polarization plane
of the antenna.
⇒
Push the antenna onto the handle until you hear the connector click into place.
See also:
Connecting Narda directional antennas
Connecting non-directional Narda antennas
Connecting cables and antennas from other manufacturers
Switching the device on
⇒
Press and hold down the key for a few seconds.
The device switches on.
The device performs a self test during the boot up process. The results are displayed on the
screen. The device starts with the last used settings.
To switch off:
⇒
Press and hold down the key for a few seconds.
The device switches off.
To force shutdown:
⇒
Press and hold down the key for at least 10 seconds to switch off the device immediately
without shutting down the operating system properly.
