Nardalert S3
19
4
Getting started
This chapter describes how to switch on the Nardalert S3 and verify it is
operating properly.
4.1 Initial display screens
4.2 Checking monitor functions
4.3 Screen navigation
4.4 Additional capabilities of optioned units
4.1 Initial display screens
The NS3 is switched on by depressing and holding the
On/Off
button on
the left side of the display. The alarm LEDs will illuminate and the
vibrator will activate before the splash screen (Figure 1) is displayed.
Figure 1:
Splash Screen
Figure 2:
Self Test
Screen
Figure 3:
Configuration
Screen
The NS3 shows each screen for a few seconds as it performs a self test,
verifies the monitor and sensor’s information and date of calibration
before beginning to measure and display detected fields.
