Napoleon PRO285X, Manual

Page: 5 / 40

5
EN
www.napoleon.com N415-0437 AUG 04.20
Handle With Care
CAUTION!
Use care when handling or transporting your grill to prevent damage and misalignment
of internal components. Although this grill has been designed with mobility in mind, rough handling or
abuse will result in damage to internal components, preventing your grill from operating properly.
!
WARNING!
The dust cap should be in place when the propane cylinder is not in use to
prevent dirt and debris from entering.
WARNING!
Review instructions on propane cylinder prior to using. A dented or rusted
cylinder may be hazardous. Discard cylinder if rust particles or debris are in the connection
area of the propane cylinder.
!
General Information
This gas barbecue is certified under Canadian and American National Standards, CSA 1.6 - 2015 and ANSI
Z21.58 - 2015 respectively for outdoor gas grills and should be installed to conform to local codes. In the
absence of local codes, install to the current CAN/CSA-B149.1 Propane Installation Code in Canada or to
the National Fuel Gas Code, ANSI Z223.1/NFPA 54 and ANSI/NFPA 58 in the United States.
Use only the pressure regulator provided with this barbecue. Replacement pressure regulators must be
supplied by or specified by the manufacturer. The regulator supplies a pressure of 11 inches water column
to the gas grill and has a female CGA#600 type fitting.
Cylinder Installation : 1 lb (.454kg) disposable cylinders to be used with this unit must be equipped with
a male CGA #600 type connection. This cylinder has a positive seating connection, which will not allow
gas flow until a positive seal has been achieved. To install the cylinder simply screw it into the regulator
- tighten hand tight. The cylinder must be an upright position, hanging down from the regulator when
operating the grill. This will prevent liquid propane from entering the regulator, which can cause over
firing and damage to the regulator.
WARNING!
Use cylinders that are marked “Propane Fuel” only.
WARNING!
Be careful not to cross thread when installing the cylinder. Do not use tools to tighten
the cylinder.
!
!