Napoleon PRO285, User Instructions

Page: 6 / 20

www.napoleongrills.com
6
Handle With Care
CAUTION!
Use care when handling or transporting your grill to prevent damage and misalignment
of internal components. Although this grill has been designed with mobility in mind, rough handling or
abuse will result in damage to internal components, preventing your grill from operating properly.
General Information
This gas grill is certified for outdoor use and should be installed to conform to local codes. Check gas type
and specifications on the rating plate located on the control panel of the grill.
Use only the pressure regulator provided with this barbecue. Replacement pressure regulators must be
supplied by or specified by the manufacturer. The regulator supplies a pressure of 2.75 kilopascals to the
gas grill and has a female CGA#600 type fitting.
Propane Cylinder Specifications
WARNING!
If these instructions are not followed exactly, a fire causing death or serious injury
may occur.
WARNING!
Do not store a spare propane cylinder on the shelf beneath the barbecue.
This gas grill has been designed for use with an approved 9 kg size propane cylinder (not supplied). The
propane cylinder must be equipped with a POL tank valve connection. A dented or rusty cylinder may be
hazardous and should be checked by your propane supplier. Never use a cylinder with a damaged valve.
The cylinder supply system must be arranged for vapor withdrawal and the cylinder shall include a dust
cap to protect the cylinder valve. The cylinder shall incorporate a listed OPD (overfill protection device).
Do not store a spare LP-gas cylinder under or near this appliance. Never fill the cylinder beyond 80 percent
full.
Cylinder Connection : 20 lb (9.1 kg). Ensure that the gas regulator hose is kink free. Remove the cap or
plug from the cylinder fuel valve. Insert the POL regulator nipple onto the POL fuel valve. Hand tighten
counterclockwise. Do not use tools. Leak test all joints
prior to using the barbecue.
A leak test must be
performed annually, and each time a cylinder is hooked up, or if a part of the gas system is replaced.
• Check that the cylinder valve is closed by turning the knob clockwise.
• Check that the grill’s burner knobs are in the off position.
• Position the cylinder so that the valve faces toward the front of the unit.
• Attach regulator hose.
WARNING!
Locate the hose out of pathways where people may trip over it or in areas where the
hose may be subject to accidental damage. Do not tip or move propane supply cylinder.
WARNING!
Use only the pressure regulator and hose assembly provided with this barbecue.
Replacement pressure regulators and hose assemblies must be specified by the manufacturer. Do not
store a spare propane cylinder on the shelf beneath the barbecue (if applicable.) The regulator must be
attached so that no part of the hose touches the underside of the grill or drippan. A fire will result if
these directions are ignored.