27
W415-0210 / R / 02.27.08
DOOR OPENING AND CLOSING:
The upper louvres must be removed to allow the door to
be opened or closed. To access the lower door latch, open the valve control door. Release
the top and bottom door latches, located at the right side of the door.
Optional plated door trim, and arched door facia are available at your local Napoleon
dealer.
NOTE: The protective wrap on plated parts is best removed when the assembly is at room
temperature but this can be improved if the assembly is warmed, using a hair dryer or similar
heat source.
A
C
B
DOOR LATCH
DOOR LATCH
HOOD
HOOD
UPPER
UPPER
LOUVRE
LOUVRE
FINISHING
LOUVRE INSTALLATION
DOOR REMOVAL AND INSTALLATION
FIGURE 56 a-c
HOOD
Attach the hood by pressing the
top fl ange into the clips along the
top of the louvre opening. Secure
using a screw through the centre
slot.
LOWER LOUVRES
Insert the hinge clips into the slots
located at the bottom left and right
corners of the unit.
To remove the louvres, pull the
back tabs of the clips forward,
while pushing the louvre assem-
bly back. Lift the clip.
UPPER LOUVRES
Insert the louvre tabs into the slots
located at the top left and right
corners of the unit.
A
CLIPS
CENTRE
SLOT
FLANGE
SLOT
TAB
B
C
HINGE
CLIP
SLOT
FIGURE 54
1
.
Place the door frame face down careful not to scratch the paint.
2
.
Center the gasketed glass inside the door frame with the thick side of the gasket
facing up.
3
.
Bend the glass retainers located along the edge of the door frame over the gasket
holding the glass in place. Careful not to break the glass.
NOTE: Care must be taken when removing and disposing of any broken glass
or damaged components. Be sure to vacuum up any broken glass from inside
the fi replace before operation.
DOOR GLASS REPLACEMENT
GLASS
GASKET
DOOR FRAME
GLASS
RETAINER
FIGURE 55
NorthlineExpress.com
http://www.northlineexpress.com
Toll-Free 1-866-667-8454
