24
W415-0341 / F / 11.21.05
Place log #1 onto the burner, centering it on the log support
and pushing it as close to the rear wall of the firebox as
possible.
Place the charcoal piece (log #5) onto the pins on the left
side of the burner.
Place log #6 onto the pins on the right side of the burner.
Sit the bottom of log #2 onto the locating pin on the left side
of the log support. Position the top of the log into the pocket
provided on the top of the rear log (#1).
GD33/34 LOG SET
A
FIGURE 50a-f
B
C
D
E
F
GLOWING EMBERS
FRONT BURNER PORTS
# 3
# 2
FIGURE 51
Position the notch located in the bottom end of log #3
against the centre grate post. Rest the top of log #3 into the
pocket at the top end of log #2.
Place the bottom of log #4 onto the locating pin on the right
side of the log support. Rest the top into the pocket pro-
vided on the center log (#3).
Tear the glowing embers into pieces and place onto the
front row of burner ports, in front of logs #5 and #6. Care
should be taken to shred the embers into
thin, small ir-
regular pieces
as only the exposed edges of the fibre hairs
will glow when exposed to direct flame; however care
should be taken to not block the burner ports. Blocked
ports can cause an incorrect flame pattern, carbon depos-
its and delayed ignition.
DOOR INSTALLATION
BGD34
SHOWN
Place the bottom of the door into the retaining bracket.
Pivot the top of the door to the firebox and secure with the
door latches.
FIGURE 52