When you remove the top cover, proceed
cautiously in order to not damage the
cables of the I/O-Panel and the Active Air
Chimney. To remove the cover completely,
you need to remove the right side panel
and disconnect the cable to the board that
goes to the switch of the Active Air
Chimney (see drawing).
FAN3
FAN2
FAN1
POWER
SWITCH
6. Fan assembly
Five 140 mm fans are pre-installed in your Deep Silence 6. You can mount up to twelve fans in
total.
We recommend the use of the 120 or 140 mm Nanoxia Deep Silence fans, available separately.
These are technically and visually equivalent to the factory-installed case fans and will work in
perfect harmony with the built-in fan control of your case.
You can, of course, connect the additional fans to the fan controller (see Chapter 7) or, where
applicable, to the Active Air Chimney (see chapter 8).
All air intake openings of the Deep Silence 6 are equipped with easy to clean dust filters. We
recommend that you clean them on a regular basis.
6.1 Fans in the front
To switch the fans in the front or to clean
the dust filters, first open the lower front
door. Next, open the “Easy Access Panel” by
pushing slightly on the left side of the panel
(
picture 6A
).
picture 6A
12
Summary of Contents for Deep Silence 6 Revision B
Page 1: ......
