Chapter 8 - Using the Web Interface
8.1 About the Web Interface
Each Trillium Compact seismometer has an integrated Web server that is available using a
standard Web browser and the RS-232 serial interface (see
"About Serial Communications" on
). This interface is provided through either the serial connector or the main connector.
Use the Web interface to retrieve information about the sensor, access state-of-health
information and control features, and to configure the sensor.
Ensure that the proxy server is disabled when using a Web browser with a Trillium
Compact seismometer.
If you are not using a Centaur digitizer, you will need to acquire a Nanometrics appliance that
converts Ethernet to Serial Line Internet Protocol (SLIP) or build your own SLIP device. For
more information, see
"About Serial Communications" on page 60
Use this interface to retrieve information about the seismometer, access state-of-health
information and control features, and configure the seismometer. Access the seismometer
Web interface through the Web interface of the Nanometrics digitizer, such as the Centaur or
by connecting the optional cable.
The serial port should not be accessed when the highest quality seismic signal is
desired as serial port traffic may cause low levels of noise on the analog output signals
of the Trillium Compact seismometer.
The home page provides links to other pages which are described in the following sections:
l
"Viewing the Current State-of-Health" on the next page
l
"Viewing Seismometer Control" on page 64
l
l
"Upgrading the Seismometer Firmware" on page 65
Chapter 8 - Using the Web Interface
16889R10 • 2020-11-12
Page 62
