Nanoleaf 867625, User Manual

Page: 7 / 27

7
Product Setup
Nanoleaf Shapes – User Manual
Mounting
Your Shapes
Product Setup
Prepare Your Surface
Prepare Your First Panel
Connect the Controller & PSU
The Nanoleaf Shapes should only be installed indoors and on a flat surface that can support the weight
of the panels. Clean your surface to be free of dust and moisture (1.1). The included Mounting Tape is
NOT
recommended for textured, porous, popcorn and ceiling surfaces (ie. wallpaper or brick walls).
Designate a panel from your setup as the starting
panel. Attach all needed linkers before you attach
any panel to the wall.
Connect your Controller and PSU into available
linker slots of the first panel. Plug the other end of
the PSU into a power source to ensure that your
setup is on and properly connected as you continue
to connect your panels together.
1
2
3
NOTE: Each standard 42W PSU supports up to 21 hexagons (2W per panel). Each Controller supports up to 500
hexagons. The Controller and PSU can be connected to any panel.
1.1 1.2