UAB “ Nano sensorics”
🎯
Pakaunės g. 70, LT
-47243 Kaunas
🌐
✉
Sensor dimensions:
Important safety information
Read this manual before attempting to install the device. UAB „ Nano sensorics” will not accept
responsibility for any damage or injury resulting from not following the instructions in this manual.
•
The sensor is for indoor use;
•
Do not disassemble, crush, puncture, short internal circuits;
•
Remove batteries if the sensor is not used, discharged battery has to be removed from the battery sensor,
in this case left batteries might leak and damage the sensor.
•
Keep the battery or device dry and away from water or any liquid as it may cause a short circuit.
•
Replace batteries only with the same or equivalent type recommended by the manufacturer
•
Discard used batteries according to the manufacturer’s instructions
•
Do not bend, deform, shred, microwave, paint the sensors, or other hardware.
•
Do not insert external material into any opening on the sensors
•
Disassembling or puncturing the battery (whether integrated or removable) can cause an explosion or fire.
•
Do not dry the sensors or battery with an external heat source such as a microwave oven or hairdryer
•
Observe proper precautions when handling batteries. Batteries may leak or explode if improperly handled.
•
The sensor is not applied as a metrological, commercial accounting purposes and UAB „Nano sensorics“
will not be held liable for any damage which may result from inaccurate readings;
•
Do not use any detergent or alcohol to clean the device;
•
Clean gently with softly moisture cloth.
