9
1.Wiring ( see sketch maps below)
①
First, be sure that the power switch of the control unit is in the " off " position. Now it is safe to connect the adapter or battery and power unit on. If the power indicator is
on that means the power supply is normal. The LCD screen will display all the relevant information for the fixture will appear, from the remaining battery power and
address in lower right corner to the lighting mode in top left corner.
②
CCT key: Press the CCT key to enter the operation interface of the CCT mode.
(
1
)
Press the CCT key to switch between soft or hard light interface.
HSI
RGBW
GEL
PRESET
MENU
LOCK
HSI
RGBW
GEL
PRESET
MENU
LOCK
Soft light interface
Hard light interface
(
2
)
DIM setting: Rotate the dimmer knob, clockwise to increase the light's brightness while counterclockwise to reduce the light's brightness. Dim shows brightness
percentage on the display. ( As shown in figure 1 )
Note: For any mode( except the RGBW mode), when pressing the " dimmer knob " , the fixture will be off and the LCD display shows the percentage of DIM is 000%.
When pressing again, the fixture is returned to its previous status. Press the knob continuously to switch the fixture between off and on. ( As shown in figure 2 )
Operating Instructions
100% 2700K +45
DIM
CCT
G/M
CCT-SOFT
PRESS “CCT” TO CHANGE TO HARD LIGHT
CH:512
NORMAL
000% 2700K +45
DIM
CCT
G/M
CCT-HARD
PRESS “CCT” TO CHANGE TO SOFT LIGHT
CH:512
NORMAL
Clockwise rotation
Counterclockwise
Figure 1
Figure 2
100% 2700K +45
DIM
CCT
G/M
000% 2700K +45
DIM
CCT
G/M
CCT-SOFT
PRESS “CCT” TO CHANGE TO HARD LIGHT
CH:512
NORMAL
CCT-SOFT
PRESS “CCT” TO CHANGE TO HARD LIGHT
CH:512
NORMAL
Figure 1