© by N&W GLOBAL VENDING S.p.A.
32
03 - 2011 3685 00
p
oWDEr
DosEs
The dispensing of powders can be controlled through
the following parameters:
D
osE
iN
grams
It is possible to set, directly in grams, the desired quan-
tity of powder for each ingredient in the drink.
The function can be used to combine one of the four
available doses of ground coffee (low, med1, med2,
high) with the selections concerned.
r
aTE
iN
g
/
sEc
.
It is possible to set the working speed of the ingredient
motors for defining the rate in g/sec.
This value is used to calculate the time
necessary to dispense the dose in grams.
D
EcaffEiNaTED
cyclE
or
sTEppED
DispENsiNg
With this function it is possible to decide, for each selec-
tion based on instant coffee in relation to the “global”
setting, whether the powder shall be dispensed with the
decaffeinated cycle or in steps.
-DECAFFEINATED CYCLE: with this parameter, the
powder is dispensed (suggested for instant coffee)
before the water, for improving the presentation of the
drink:
-IN STEPS: with this parameter the powder is dispensed
in steps (which can be set from 1 to 5) at the same time
of the water.
D
rip
For each selection it is possible to define the waiting time
(programmable from 0 to 2000 hundredths of a second)
from the end of dispensing to the closure of the shifting
system in order to give the tubes time to empty.
s
TaTus
of
sElEcTioN
For each selection key it is possible to define whether it
shall be enabled or not.
a
ccEssoriEs
Function not available on the model described in this
manual.
complETE
sElEcTioN
TEsT
With this function it is possible to obtain for each se-
lection, with the door open and without inserting the
amount, the dispensing of:
-complete selection
-only water
-only powder
p
roDucT
coDE
This function can be used to assign a 16-character
(alphanumeric) identification code to each selection for
statistical processing.
g
lobal
poWDEr
DosEs
With this function it is possible to adjust at the same time
the powder dose of each ingredient motor related to
several selections.
Use the keys
�
and
�
to scroll all the powders, press
the confirmation key
�
for setting the grams of chosen
powder.
D
osErs
sETTiNg
For the correct conversion of the amounts of the product
dose it is possible to set the value of the rate of each
of the dosers in g/sec for calculating the grams to be
dispensed.
k
EyboarD
k
Ey
<--->
sElEcTioN
With this function it is possible to vary the order of the
selections associated with the keyboard defined by the
layout that has been set.
The display will show, in a sequence, the list of the fore-
seen selections and by pressing the destination key, the
match is stored.
v
ErificaTioN
No
.
of
sElEcTioN
This allows you to verify the selection number matched
to a key.
D
EcaffEiNaTED
cyclE
This function acts on the selections based on instant cof-
fee. The selections are identified in the layout as unmodi
-
fiable.
By enabling this function in all the selections based
on instant coffee (if present) the powder is dispensed
before the water
For each selection based on instant coffee it is however
possible to change this parameter individually.