Nakayama 024286, Owner'S Manual

Page: 8 / 23

8
WWW
.N
AKAYAMA
T
OOLS
.
COM
Before working on the device, disconnect it from the power supply.
Use only original parts and be careful when assembling the brushcutter. Risk of injury!
Before working, you must mount the safety guard on the cutting device, and the two tubes.
Assemble the tool as explained below and use the pictures above.
Mounting the two tubes of the shaft (fig 2)
1. Push the two parts of the tubular shaft together (hole at the top of the bottom tube); you will hear a click.
2. Put and tighten the screw cap in the correct direction.
3. Before starting the machine, check that the lower tube is firmly installed and secured. Before starting the machine, make
sure that the rod of the tube is closed and secure and that it is in the correct position.
Dismantling
to disassemble, proceed in the reverse direction of 8.1, Lift the cover plate, press the locking tab and remove the lower tube.
Mounting the handlebar (fig 3)
1. Loosen the 4 Allen screws (A) on the upper tube and remove the handlebar bracket.
2. Insert the handlebar onto the bracket; tighten it with the bracket and the 4 Allen screws (as shown).
3. Secure the wiring with the large clip to the upper tube and a smaller clip on the multifunction handle.
Make sure the wiring is not bent or broken.