Nakanishi AL-H1206, Operation Manual

Page: 2 / 11

11
English
1 . CAUTIONS FOR HANDLING AND OPERATION
■
Read these warnings and cautions carefully and only use in the manner intended.
■
These warnings and cautions are intended to avoid potential hazards that could result in personal injury to the
operator or damage to the device. These are classied as follows in accordance with the seriousness of the risk
.
Class
Degree of Risk
WARNING
A safety hazard could result in bodily injury or damage to the device if
the safety instructions are not properly followed.
CAUTION
A hazard that could result in light or moderate bodily injury or damage to
the device if the safety instructions are not followed.
WARNING
① Handling
Connection to the Air Line Kit should be performed by a person with experience with
compressed air and air compressors.
② Air Pressure
Compressed air is required. Do not exceed an air pressure of 1.0MPa (145psi) at primary side
and 0.85MPa (123.3psi) at secondary side of the Air Line Kit.
③ Use of Clean Air
Do not use compressed air contaminated with chemicals, oil compounds, organic solvents,
salinity or corrosive gasses in order to avoid damage to the device.
④ Connection of connection hose and supply air / oil hose
Connect the input connection hose and supply air / oil hose securely to avoid accidental
disconnection during use. Input air pressure should never exceed 1.0MPa (145psi).
Pressure exceeding 1.0MPa (145psi) may cause the connection hose and supply air / oil hose
to rupture.
⑤ Inlet and Outlet Connections
Do not hit, impact or cause shock to the Inlet or Outlet Connector Connections. Never put undo
stress or load on the Inlet or Outlet Connector Connections. Any damage to these components
can cause air leakage and the inability of the inlet or outlet quick disconnect to adequately
secure the connection hose and supply air / oil hose.
⑥ Mounting the Air Line Kit
When installing the Air Line Kit, securely install the Air Line Kit by mounting it on a at, level
surface. If the Air Line Kit is dropped, damage to the Air Line Kit and injury to the operator is
possible.
⑦ Filter Regulator Bowl
・ The bowl is made of a polycarbonate.
Do not use the Air Line Kit in conditions where chemicals or organic solvents are present in
the atmosphere.
・ Do not remove the bowl guard. Using the Air Line Kit without the bowl guard may cause
injury to the operator should the bowl burst.
・ When removing the bowl from the regulator, remove all pressure from the Input and Outlet
sides of the Air Line Kit.
Thank you for purchasing the " AL - H1206 " Air Line Kit. This Air Line Kit designed for adjust the air supply ow and
oil amount for automatic mist lubrication to Air Grinder. The Air Grinder and a Compressor are required in addition
to this Air Line Kit. Read this and all the associated component Operation Manuals carefully before use. Always
keep this Operation Manual in a place where a user can referred to for reference at any time.