Nakanishi AL-H1206, Operation Manual

Page: 7 / 11

16
8
. OPERATION
S S O
H L
Release
Lock
H : Increased
O : Draining S : Stop Draining
Drain Outlet Port
Drain Valve
L : Decreased
Regulator Knob
Pressure Gauge
Filter Section
Bowl
Fig. 2
S S O O
Adjusting Dome
Oil Filler Cap
Upper Oil Limit
Lower Oil Limit
Window
Oil Reservoir
O
：
Draining S
：
Stop Draining
Hand Operating Knob
Oil Output Port
Fig. 3
CAUTION
・ Make sure to turn the compressed air supply to the
Air Line Kit is OFF, before replacing the Lubricating
Oil or draining the water in Lubricating Oil.
・ Check the Lubricating Oil level everyday and before
use. If Lubricating Oil level is low, Fill the oil bowl with
Lubricating Oil up to the Upper Oil Limit on the bowl.
・ If collected water in the lubricator taints Lubricating
Oil, replace the Lubricating Oil immediately.
8 - 1 Filter Regulator (Fig. 2)
(1) Regulator Section
＜ Lock and Release of the Regulator Knob ＞
Regulator Knob is equipped with Lock mechanism.
Release : Pull the Regulator Knob OUT to unlock.
Lock
: Push the Regulator Knob IN to the Lock position.
＜
Adjusting Air Pressure
＞
Turn the Regulator Knob while watching Pressure Gauge
increase or decrease.
H direction : Air pressure is increased.
L direction : Air pressure is decreased.
(2) Filter Section
The water, dirt and debris are separated from the
compressed air.
The separated debris is collected in the Bowl.
＜ Draining ＞
Opening and closing the Drain Valve.
O direction : Draining.
S direction : Stop draining.
＜
To divert the drain to another location
＞
Connect a hose with a
ȭ
6mm I.D. (Not included / provided
by the end-user.) to the Drain Output Port and divert to
another location.
8 - 2 Lubricator (Fig. 3)
(1) Oil Amount (Fig. 3)
Check the Oil Amount in the Window.
If the Lubricating Oil level is low, add additional oil.
（
Supply Lubricating Oil to Upper Oil Level Limit of Fig. 3.
）
(2) Replacing the Lubricating Oil and draining the water in
the Lubricating Oil (Fig. 3)
Opening and closing the Hand Operating Knob.
O direction : Draining.
S direction : Stop draining.
＜
To divert the Lubricating Oil and drain the water to
another location
＞
Connect a hose with a
ȭ
6mm I.D. (Not included /
provided by the end-user.) to the Oil Outlet Port and divert
to another location.