7
Nagra –
JAZZ
Front panel
1.
LED and Modulometer intensity switch, pushed up will increase the
intensity, down will reduce it, there are 7 levels of intensity
2.
Nagra Modulometer indicates the output level in dB, reference 0 dB = 1 V
3.
STEREO / MONO selector, in
MONO
position, the LED will light up
4.
MUTE, when muted the LED will light up, push down to cancel the mute,
you can also MUTE using the remote control
5.
Volume adjustment potentiometer
6.
Balance fine adjustment potentiometer
7.
Gain selection, standard position 0 dB, upward po12 dB
8.
Line out selection, position
1
XLR,
2
RCA
9.
Motorized Main selector,
OFF
is standby* position, input selection
A
to
E
10.
IR window and remote LED
*In standby mode the power consumption is less than 10 mW.
Please note that when turned
ON
, the JAZZ will go through a 2 minute pre-
heating phase. This is in order to optimize the warming-up of tubes and critical
components. This will allow your JAZZ to offer excellent performance for a longer
period, the components being taken care of gently.
Note:
In case of an accidental return to the
OFF
position for less than 2 seconds,
the pre-heating is not reapplied.
Note 2:
When moving between the
A
and
E
inputs, a 3 second switching delay is
applied to avoid any unwanted noise, this is perfectly normal.
1.
3.
2.
4.
5.
6. 7.
8.
9.
10.
