Slide the module into its own place and fasten it with the screws.
4.2 Tail cable sizing
•
Place the tail cable on its own splice tray loosely from below. To the side where the
attachment hooks are.
•
Measure the tail cable so that the about 30 mm of the cable jacket is on the splice tray and
about 120 cm peeled fiber is on the tray. Mark the cable jacket peeling point and cable cut-
off point.
•
Cut the cable to a suitable length.
•
Remove the splice tray from its holder and place it on the installation table.
•
Peel the cable and remove unnecessary wires and filling and center elements. Attach the end
of the tail cable to the opposite side with cable ties as the previously fastened.
Peel the fiber tubes to approx. 6cm in length, remove the
gel.
•
If you are using Naficon's universal splice trays, rotate the
fiber bundles for the two upper splice protection sleeves by
using the whole splice tray and take them from the right
side to the splice protection sleeves.
