CONDITION
POSSIBLE CAUSES
POSSIBLE SOLUTIONS
No sound from all channels.
• AC power unplugged.
• Check AC cable connection and outlet.
• Power not switched on.
• Outlet has no power.
• Mute function is activated.
• Toggle [MUTE] button to deactivate Mute
function.
No sound from some channels.
• Faulty/missing cables.
• Check cables.
• “Speaker Configuration” channel (s) set to “OFF”.
• Check “Speaker Configuration” menu.
No sound from surround channels.
• No surround listening mode is engaged.
• Select appropriate listening mode.
• Surround channels set to “OFF” on “Speaker
Configuration” menu.
• Correct “Speaker Configuration” or “Speaker
Levels” settings.
• Surround channels level set too low on
“Speaker Levels” menu.
No sound from Subwoofer.
• Subwoofer is off, not powered or improperly
connected.
• Power up subwoofer, check subwoofer’s
AC outlet or check connections.
• Subwoofer set to “OFF” on “Speaker
Configuration” menu.
• Correct “Speaker Configuration” or “Speaker
Levels” settings.
• Subwoofer level set too low on “‘Speaker Levels”
menu.
No sound from Center channel.
• Source is a 2/0 (etc.). Dolby Digital or DTS
recording without center channel.
• Play a known 5.1-channel recording or
select Dolby Pro Logic IIx Music mode.
• Center set to “OFF” on “Speaker Configuration”
menu.
• Correct “Speaker Configuration” or “Speaker
Levels” settings.
• Center level set too low on “Speaker Levels”
menu.
No Dolby Digital/DTS.
• Source’s digital output is not connected to a
T 758 digital input.
• Check connections.
• Source component not configured for
multichannel digital output.
• Check source component setup.
T 758 does not respond to remote control
commands.
• Batteries are flat or incorrectly inserted.
• Check batteries.
• Infrared receiver (IR) window of T 758 or IR
transmitter of the remote control is obstructed.
• Check IR windows and ensure clear line-
of-sight from remote to T 758.
• T 758 front panel is in very bright sunlight or
ambient light.
• Reduce sunlight/room lighting.
No RDS information.
• Station signal too weak.
• Check station tuning. Adjust or replace
antenna.
• Station not transmitting RDS data.
• Tune to an RDS station that supports
program-service name (PS mode) and
radio-text mode (RT).
Display shows “No Service List”.
• DAB antenna not connected properly.
• Check the connection and position of DAB
antenna.
• No DAB coverage in the area.
• Call your local DAB broadcast providers for
coverage information.
Reset T 758 to factory default settings:
Press and hold [SOURCE
4
] and [MENU] front panel buttons until “Factory Reset..complete.” is shown in the VFD.
REFERENCE
TROUBLESHOOTING
40
ENGLISH
POR
TUGUÊS
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ
